Repair ZIL-5301
Maintenance of the ZIL-5301 clutch
Adjustment of the clutch drive
Maintenance of the clutch consists of checking and adjusting the full travel of the clutch pedal, the free travel of the piston pusher of the master cylinder,
Checking the tension of the generator, water pump, and compressor drive belts D-245E3
Check every 5 thousand km.
Check using the KI-8920 device in the following order:
The design of the rear brake working cylinders is shown in the figure.
To remove the rear brake working cylinder from the car, it is necessary to disassemble the brake mechanism, as described in the article - ZIL-5301 rear wheel brakes
Before starting work, the car should be cleaned of dirt and washed.
To remove the front axle from the car, you need to lift the car and install stands under the front axle beam, unscrew the wheel mounting nuts and remove them.
The fuel supply drive device is shown in Fig. 1.
The drive can be disassembled and assembled in any sequence.
When assembling the drive, it must be adjusted in the following order:
Fuel level sensor connection diagram
On ZIL-5301 cars and buses manufactured before 01.09.01, an electric motor 351.5205 and a washer mod. 11.5208 with an electronic control unit mod. BUS 1.92.3761, located in the cabin under the instrument panel on the left side of the driver next to the hood release handle, were installed to drive the windshield wiper.
