Repair ZIL-5301
Installing the rear sheet, cuff housing and flywheel of the D-245 crankshaft
The rear sheet should fit tightly on the pins pressed into the cylinder block
Basic instructions for disassembling and assembling the D-245E3 water pump
Disassembling the water pump
Remove the pump from the engine.
The design of the rear brake working cylinders is shown in the figure.
To remove the rear brake working cylinder from the car, it is necessary to disassemble the brake mechanism, as described in the article - ZIL-5301 rear wheel brakes
Adjusting the ZIL-5301 Parking Brake
The ZIL-5301 vehicles and AMO ZIL buses are equipped with a parking brake system driven by a spring energy accumulator (Fig. 1)
Requirements for parts and assemblies of the D-245 diesel engine
The cylinder block is the main body part of the diesel engine and is a rigid cast iron casting.
Four removable liners made of special cast iron are installed in the vertical bores of the block.
The ZIL-5301 and its modifications are equipped with a voltage regulator mod. 4202.3702 (installation of mod. 206.3702 or 207.3702 is possible), designed to work with the generator mod. 2022.3771, and having two isolated terminals "Ш" and "+"
Adjusting the contact patch in the main transmission gears of the ZIL-5301
After adjusting the main transmission bearings, it is necessary to check the engagement of the teeth of the driving and driven bevel gears (on the paint on the contact patch) and, if necessary, adjust the engagement and set the required gap between the teeth.
