car UAZ-3151
Place the vehicle on a platform or inspection ditch to gain access from below to the gearbox and clutch
During repairs, brake pads and wheel cylinders or parts included in them usually need to be replaced, for the removal of which there is no need to remove the entire brake mechanisms
The tanks are attached to the frame side members from the outside using brackets and clamps. Cardboard spacers are placed between the clamps and the tank
Procedure for disassembling and assembling carburetors K-151V, K-151E and K-151U
Disassemble the carburetor in the following sequence:
Maintenance of the rear axle consists of maintaining the oil level in the crankcase and timely replacing it, checking seals, timely detection and elimination of axial clearances in the final drive gears
The hubs of the front and rear wheels (see Fig. 1 and 3) of all cars, except for cars with final drive axles, are the same
Remove and disassemble the main brake cylinder in the following order:
Disconnect the lines leading from the master cylinder to the warning device.
