car MAZ
The nozzle is designed to inject fuel into the engine combustion chamber in a finely atomized state
Power steering pump for MAZ vehicle with flow and pressure valve
The NSh-32U gear pump consists of a housing 6 (Fig. 1) and two gears placed in it: driving 7 and driven 9, rotating in bronze bushings
Only the crankcase, input shaft bearing cap, intermediate shaft, reverse gear block, third gear of the output shaft, oil pump housing and base are subject to repair in the gearbox
Remove the cylinder head cover (650.1003256 - assembled).
Release the injector harness from the bracket brackets
The switch type VK 860B is designed to connect batteries to the vehicle ground and disconnect them
The design of the switch is shown in fig. 1.
Removing the electronic control unit (ECU)
Disconnect intermediate harness (1) (650.3724014), engine sensor harness (2) (650.3724012) and injector harness (3) (650.3724010) from the electronic control unit.
Installing cylinder heads, valve rocker arms and adjusting valve clearances
The cylinder head mounting studs are screwed into the right and left rows of the cylinder block, having previously lubricated the threaded holes for the studs in the block with diesel oil
