car GAZ-2705
Removing the bridge from the vehicle must be done in the following sequence:
- - loosen the rear wheel nuts;
Insufficient belt tension impairs airflow to the radiator of the cooling system and leads to engine overheating and increased belt wear.
If the belt tension is too high, the fan drive and tension roller bearings may fail.
On cars with a ZMZ-406 engine, a starter 42.3708-10 is installed on the clutch housing on the right side, and with a ZMZ-402 engine - ST230-B4 - on the left side of the clutch housing
Remove the steering column lining
Disconnect the wires from the brake light switch
Defection and repair of the ZMZ-405 GAZ-2705 cylinder block
To determine the technical condition and repair of the cylinder block, remove the engine from the car and disassemble it
The crankshaft is cast from high-strength cast iron, five-bearing, has eight counterweights for better unloading of the supports
If an oil leak through the oil pan gasket cannot be eliminated by tightening its mounting bolts, it means that the gasket is severely deformed and must be replaced.
