car ZIL-131
Checking the ZIL-131 pneumatic drive for serviceability
Before driving, make sure that the pressure in the system is not lower than 4.5 kg/cm 2
The starting engine heater is designed to warm up the engine before starting it at low ambient temperatures
Installing the ignition during engine assembly, as well as on engines from which the distributor and distributor drive have been removed, must be done in the following order:
The engine fuel system is forced, with fuel supplied by a diaphragm-type fuel pump
The pressure regulator is installed on the compressor cylinder block. To increase the reliability of the pressure regulator, it is equipped with two filters:
The compressor is a piston type, non-straight-through, two-cylinder, single-stage compression
Check the angular free play of the steering wheel daily with the engine idling by rocking the steering wheel back and forth until the steering wheels begin to turn.
