Repair Lada Priora

Remove the front wheel from the side of the tie rod end being replaced

Removing and installing the rear brake drum

The maximum permissible diameter of the drum working surface is 201.5 mm

Removing the automatic transmission is discussed in the article - "Removing the automatic transmission"

Install the automatic transmission on the workbench

The gear shift drive consists of a gear shift lever, a ball joint, a rod, a gear selection rod, and gear selection and shift mechanisms

Work with an assistant on an inspection ditch or overpass

Drain the oil from the gearbox.

Disconnect the wire terminal from the negative terminal of the battery.

Front brake mechanism is disc, ventilated, with a floating caliper and one working cylinder

The brake disc is cast iron, its minimum permissible thickness when worn is 17.8 mm.