car GAZ-3110
We remove the spark plug tips along with the high-voltage wires, the ignition coils (you can only disconnect the connectors, leaving them on the valve cover), the throttle drive cable and, having disconnected the wires from the lubrication and cooling system sensors, remove the wiring harness from the head cover brackets
Clean the air release valve on the wheel from which air will be removed from dirt and dust
Mass air flow sensor – thermopneumatic flow meter IVKSH 407282000, installed in the intake system after the air filter.
The sensor determines the amount of air entering the cylinders during engine operation.
Generators 1631.3701 or 192.3771 do not have a built-in voltage regulator and work in conjunction with a transistor voltage regulator type 13.3702–01, which has electronic protection against short circuits in the generator excitation winding circuit
The carburetor should be removed from the engine mainly to flush it from dirt and resins, since repairs and adjustments of most of its systems and elements can be carried out without dismantling
We install the car on a viewing hole or on a lift
Remove the engine in the following order:
